Amptweaker DeFizzerator - Passive EQ

Various

Amptweaker

Amptweaker DeFizzerator Passive EQ

Cumming, GA, Dec 15, 2016

With the introduction of effects loops on the back of Amptweaker pedals, it soon became obvious that in addition to adding other effects, users could easily modify the tone of the pedal by patching an EQ in the loop, since it turns off and on with the footswitch.  One of the most common things that vary from one amp/speaker to the next is the sizzle, edge or ‘fizz’.  So the DeFizzerator was born to address that issue.  A simple passive low impedance EQ rolls of highs at one of three very high frequencies, Fizz, Buzz, or Crackle. 

The Fizz is the highest frequency, and the Crackle is a little higher frequency than a regular High control, so these are higher than most typical amp EQs, and really are in the range where amp designers tweak for their trademark highs.  The single knob mini pedal is always on, requires no batteries, and adds no noise to the system….it just cuts the fizz!

The DeFizzerator also works after any kind of buffer, or with pedalboard switcher systems, or even in the effects loop of an amplifier, to effectively knock down the edge.  While more obvious when used with a heavier sounding amp with more high harmonics, it also can help soften the bite of a cleaner blues amp.

And since the Amptweaker Pro pedals all have a separate loop for the Boost channel, the DeFizzerator pedal can be patched in there to dial the tone down a bit on the higher gain tone, for players who want the boosted gain tone to closer match the un-boosted tone.

Most recent forum threads

Where to find one?


your browser doesn't support AJAX?


fx pedal stompbox stomp box guitar effects pedal equalizer eq equaliser eq/excite/filter
Syndicate content



Subscribe to our newsletter

Close
Also check out Effects Database's social media accounts: